A new collaboration between Adafruit & Micah from Scanlime, we are...
You want to make a cool robot, maybe a hexapod walker, or maybe just a...
WHAT IS DOBOT MOOZ? DOBOT MOOZ, the industrial grade transformable...
What Is DOBOT Magician DOBOT Magician is a multifunctional desktop...
Reach RS cable 2m w/o 2nd connector
Reach RS+ RTK GNSS receiver with an app as a controller Reach RS is...
If you need to connect a DC power wall wart to a board that doesn't have...
OpenEP4CE10-C Standard, ALTERA Development Board
Make a 1 Watt flashlight or a headlamp with this ultra-bright LED. The LED is very bright, with 90 Lumens in a 140 degree lambertian pattern. Compared to most LEDs, you would say this is 30,000 millicandela. Either way, its incredibly bright! The output is a 'cool' 6000K pure white, not a 'warm' incandescent-looking white.
NOOBs is the fastest way to get the various operating systems for your Raspberry Pi. This 16GB Micro SD card can boot multiple operating systems, allowing quick and easy set-up of your Raspberry Pi.
This lovely little display breakout is the best way to add a small, colorful and bright display to any project.
Z-axis tape is made by 3M, and is used to bond two conductive surfaces together and allow a small.
Power supply for PHPoC with standart conector. DC Output Voltage: +5v DC Output Current: 1A Output Power: 5W
This chip perform bidirectional level shifting from pretty much any voltage to any voltage and will auto-detect the direction.
This is the 8-Channel PWM or Servo FeatherWing, you can add 8 x 12-bit PWM outputs to your Feather board.
This is a 9V battery pack with on/off switch and a pre-attached 5.5mm/2.1mm barrel plug. Use this to battery-power your Arduino (or other electronic projects) - it's ready to go out of the box!
This lovely little shield is the best way to add a small, colorful and bright display to any project. We took our popular 1.8" TFT breakout board and remixed it into an Arduino shield complete with microSD card slot and a 5-way joystick navigation switch (with a nice plastic knob)!
This chip can handle up to 12 individual touch pads.
If you'd like a compact display, with buttons and a joystick - we've got what you're looking for.
You want to make a cool robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to drive a lot of LEDs with precise PWM output. Then you realize that your microcontroller has a limited number of PWM outputs! What now? You could give up OR you could just get this handy PWM and Servo driver breakout.