The E3D V6 Hot End: Smaller, Easier, High Performance The E3D V6 is our...
Acoplador flexible de 5mm a 8mm, usado comúnmente como acoplador para el...
Acoplador flexible de 5mm a 5mm, usado comúnmente como acoplador para el...
Bowden tube connector 3mm (2.85mm)
Bowden tube connector 1.75mm
Mega 2560 R3 (Compatible) 16u2 Este se trata de un clon de gran calidad,...
Se usa para sistemas de extrusión basados en bowden.
Shield that translates digital commands to power command for the...
Make a 1 Watt flashlight or a headlamp with this ultra-bright LED. The LED is very bright, with 90 Lumens in a 140 degree lambertian pattern. Compared to most LEDs, you would say this is 30,000 millicandela. Either way, its incredibly bright! The output is a 'cool' 6000K pure white, not a 'warm' incandescent-looking white.
NOOBs is the fastest way to get the various operating systems for your Raspberry Pi. This 16GB Micro SD card can boot multiple operating systems, allowing quick and easy set-up of your Raspberry Pi.
This lovely little display breakout is the best way to add a small, colorful and bright display to any project.
Z-axis tape is made by 3M, and is used to bond two conductive surfaces together and allow a small.
This chip perform bidirectional level shifting from pretty much any voltage to any voltage and will auto-detect the direction.
This is the 8-Channel PWM or Servo FeatherWing, you can add 8 x 12-bit PWM outputs to your Feather board.
This is a 9V battery pack with on/off switch and a pre-attached 5.5mm/2.1mm barrel plug. Use this to battery-power your Arduino (or other electronic projects) - it's ready to go out of the box!
This lovely little shield is the best way to add a small, colorful and bright display to any project. We took our popular 1.8" TFT breakout board and remixed it into an Arduino shield complete with microSD card slot and a 5-way joystick navigation switch (with a nice plastic knob)!
This chip can handle up to 12 individual touch pads.
If you'd like a compact display, with buttons and a joystick - we've got what you're looking for.
You could give up OR you could just get our handy PWM and Servo driver shield. It's just like our popular PWM/Servo Breakout but now Arduino-ready and works with any Arduino that uses shields: Uno, Leo, Mega, ADK, its all good.
Instead of asking the Pi Linux kernel to send these signals, pop on this handy HAT! It adds the capability to control 16 Servos with perfect timing. It can also do PWM up to 1.6 KHz with 12 bit precision, all completely free-running.