The E3D V6 Hot End: Smaller, Easier, High Performance The E3D V6 is our...
Acoplador flexible de 5mm a 8mm, usado comúnmente como acoplador para el...
Acoplador flexible de 5mm a 5mm, usado comúnmente como acoplador para el...
Bowden tube connector 3mm (2.85mm)
Bowden tube connector 1.75mm
Mega 2560 R3 (Compatible) 16u2 Este se trata de un clon de gran calidad,...
Se usa para sistemas de extrusión basados en bowden.
Shield that translates digital commands to power command for the...
This fully assembled and tested kit gives you the hardware needed to do the Teensy Audio library tutorial. No soldering required. It's fully tested and ready to use.
This audio adaptor lets you easily add high quality 16 bit, 44.1 kHz sample rate (CD quality) audio to your projects with Teensy 3.0, 3.1, 3.2, 3.5 or 3.6. It supports stereo headphone and stereo line-level output, and also stereo line-level input or mono microphone input.
This 320x240 color TFT display is recommended for use with Teensy 3.2, for high resolution color graphics. It can be used with the Adafruit_ILI9341 library or Optimized ILI9341 library. ILI9341_t3 supports large high-res fonts. A library of additional fonts is available, as well as huge collection of Google fonts.
This low-cost Prop Shield is meant for making light and sound effects on small handheld props and wearable costumes. Audio Amplifier - Clear quality audio output to a small speaker. Fast LED Driver - Drive APA102 / Dotstar LEDs for colorful lighting with rapid response. Flash Memory - 8 Mbyte storage for images, sound clips, and data logging.
Socket, 14 pins, 0.1 inch (2.54 mm) spacing
Socket, 24 pins, 0.1 inch (2.54 mm) spacing
The Teensy USB Development Board is a complete USB-based microcontoller development system. Teensy 3.2 is a direct, 100% compatible replacement for Teensy 3.1. It is fully compatible with all shields and add-on boards made for Teensy 3.1, including the Audio Board and OctoWS2811 Adaptor. All Teensy boards are shipped assembled and fully tested.
Actual size is 2.4 by 0.7 inch The Teensy USB Development Board is a complete USB-based microcontoller development system. Version 3.5 features a 32 bit 120 MHz ARM Cortex-M4 processor with floating point unit. All digital pins are 5 volt tolerant. All Teensy boards are shipped assembled and fully tested.
This short cable allows mounting Teensy 3.0 inside an enclosure, with a sturdy standard B type connector. The Teensy is protected from excessive force applied to the panel mounted connector.Micro-B works with Teensy 3.1 and Teensy-LC. Micro-B does not work with Teensy 2.0 (requires Mini-B).
Build a custom USB gamepad that has an accelerometer mouse inside!