SMARTFIL PLA: Filamento PLA para impresora 3D
Build a custom USB gamepad that has an accelerometer mouse inside!
Turn your Raspberry Pi into a retro games console! Picade HAT includes...
NOOBs is the fastest way to get the various operating systems for your Raspberry Pi. This 16GB Micro SD card can boot multiple operating systems, allowing quick and easy set-up of your Raspberry Pi.
Fully assembled 3.5inch display with 480x320 pixels TFT LCD and a resistive touch overlay. Just plug it on top of ODROID-C2/C1+/C0.ODROID-XU4 needs the Shifter-Shield board to use this display.You will need an official Ubuntu image to configure it. You can simply download the Kernel updates (via dist-upgrade) and configure your ODROID for this display...
This heatsink might be useful for who needs a low noise solution with ODROID-XU4. The stock active cooler mounted on the XU4 is more efficient at dissipating heat away from the processor for most of use cases.
Power supply for PHPoC with standart conector. DC Output Voltage: +5v DC Output Current: 1A Output Power: 5W
5V/2A Power Supply EU Plug for ODROID-C1+ / C0 / C2
5V / 4A Power Supply EU Plug for ODROID-XU4.
High quality stable and low noise power supply for XU4.
This is a 9V battery pack with on/off switch and a pre-attached 5.5mm/2.1mm barrel plug. Use this to battery-power your Arduino (or other electronic projects) - it's ready to go out of the box!
Never hunt around for another crystal again, with the Si5351A clock generator breakout from Adafruit! This chip has a precision 25MHz crystal reference and internal PLL and dividers so it can generate just about any frequency, from <8KHz up to 150+ MHz.
This lovely little shield is the best way to add a small, colorful and bright display to any project. We took our popular 1.8" TFT breakout board and remixed it into an Arduino shield complete with microSD card slot and a 5-way joystick navigation switch (with a nice plastic knob)!
You could give up OR you could just get our handy PWM and Servo driver shield. It's just like our popular PWM/Servo Breakout but now Arduino-ready and works with any Arduino that uses shields: Uno, Leo, Mega, ADK, its all good.
Instead of asking the Pi Linux kernel to send these signals, pop on this handy HAT! It adds the capability to control 16 Servos with perfect timing. It can also do PWM up to 1.6 KHz with 12 bit precision, all completely free-running.