No products
Este conector micro HDMI a HDMI es realmente útil si ya tiene un cable...
Argon One Case es el estuche ergonómico y estéticamente agradable que...
ABS 3D printing Filament. Temperatura de extrusión aproximada: 200º - 240ºC
ExcelFil TECH is a high grade, composite 3D printing filament and is...
Make a 1 Watt flashlight or a headlamp with this ultra-bright LED. The LED is very bright, with 90 Lumens in a 140 degree lambertian pattern. Compared to most LEDs, you would say this is 30,000 millicandela. Either way, its incredibly bright! The output is a 'cool' 6000K pure white, not a 'warm' incandescent-looking white.
NOOBs is the fastest way to get the various operating systems for your Raspberry Pi. This 16GB Micro SD card can boot multiple operating systems, allowing quick and easy set-up of your Raspberry Pi.
This lovely little display breakout is the best way to add a small, colorful and bright display to any project.
Z-axis tape is made by 3M, and is used to bond two conductive surfaces together and allow a small.
Make a portable power brick with plenty of juice!
This chip perform bidirectional level shifting from pretty much any voltage to any voltage and will auto-detect the direction.
This is the 8-Channel PWM or Servo FeatherWing, you can add 8 x 12-bit PWM outputs to your Feather board.
This is a 9V battery pack with on/off switch and a pre-attached 5.5mm/2.1mm barrel plug. Use this to battery-power your Arduino (or other electronic projects) - it's ready to go out of the box!
Never hunt around for another crystal again, with the Si5351A clock generator breakout from Adafruit! This chip has a precision 25MHz crystal reference and internal PLL and dividers so it can generate just about any frequency, from <8KHz up to 150+ MHz.
What's better than a single LED? Lots of LEDs!
What's better than a single LED? Lots of LEDs!
This chip can handle up to 12 individual touch pads.