Acoplador rigido de 5mm a 8mm, usado comúnmente como acoplador para el...
Diámetro exterior: 15mm Diámetro Interior: 8mm Longitud: 24mm Peso: 2g
Long gone are the days of parallel ports and serial ports. Now the USB...
3D printer Fan 30/10 Adapter V6
3D printer Fan 40/20 turbine
3D printer Fan 40/20
3D printer Fan 25/10
The HiKey970 features the HiSilicon Kirin 970 SoC with HiAI Architecture...
NOOBs is the fastest way to get the various operating systems for your Raspberry Pi. This 16GB Micro SD card can boot multiple operating systems, allowing quick and easy set-up of your Raspberry Pi.
This heatsink might be useful for who needs the full throttled quad-core performance with ODROID-C1.
for ODROID-C1+ / C0 / C2DC Plug specification : Inner diameter 0.8mm and outer diameter 2.5mm Center is positive (RED wire) and outer is negative (BLACK wire)Cable Length : 270mm approx. (10 inch)
Cable Ethernet Cat6
Works with ODROID-C1 / C1+ / XU4(combination with XU4 Shifter Shield)What's better than a single LED? Lots of LEDs!
The myAHRS+ is a high performance AHRS(Attitude Heading Reference System). Its attitude output is more stable to acceleration and magnetic disturbances. Communication and configuration are enabled via UART/USB interface for user applications. I2C interface is available for embedded application like Arduino projects.
Odroid USB Plug and play GPS module.
Add-on sensor board for ODROID-SHOW The Weather board is an easy to use ODROID-SHOW Add-on that grants you access to UV Index, Barometric pressure, Altitude, Relative humidity, Illumination,Temperature. - Dimension is only 20 x 20 mm- Sensors : Si7020, BMP180, Si1132- Recommended working voltage : 2.7 ~ 3.6 Volt
Ultra-fast: Capture Video and Photos 2x Faster than Typical Memory Cards Extra Powerful: Maximize the Storage Capacity of your Advanced Devices 16GB
Tripod mount for oCam camera - Compatible with oCam : 5MP USB 3.0 Camera and oCam-1MGN-U : Global Shutter- Provides the standard hole size for camera tripods, 1/4"-20UNC
USB to IO expansion board that provides GPIO/PWM/SPI/UART/I2C/ADC interfaces. It uses 3.3V/5V compatible PIC18F45K50-QFN USB Microcontroller. It includes 28 pin headers to make it easy to plug into a breadboard or other circuit. It has a bootloader that allows for downloading or upgrading the firmware.
USB host port on your PC or Smartphone chargers can supply the power to ODROID-C via this cable.