EDGE Advanced drone controller with HDMI video input and 5.8 GHz data...
Oh so handy, this little lipo charger is so small and easy to use you...
Digital Bitbox is a minimalist bitcoin hardware wallet packed with...
Compatible with XU / XU3 / XU4 Series4 x buttons (GPIO)1 x button (Power On)5 x LEDs (GPIO)1 x SPI Flash 2Mbit (Upto 20Mhz SPI clocking)1 x I2C Temperature/Pressure sensor BMP1801 x I2C Ambient Light sensor BH1780GLI1 x Trimpot(variable resistor) for ADC access1 x IDC cable is included.
The HiFi Shield Plus provides both stereo RCA connectors to connect to external amplifiers and other audio equipment. Via TI's high-end PCM5242 DAC chip(known as Burr-Brown), it supports 16, 24, 32 bit audio formats with minimal THD+N ratio (0.002%) and ideal dynamics (114dB+), plus amazing sampling rates of 384kHz
The HiFi Shield provides both stereo RCA connectors and a 3.5mm stereo jack (all gold-plated) to connect to external amplifiers and other audio equipment. Via TI's high-end PCM5102 DAC chip, it supports 16, 24, 32 bit audio formats with minimal distortion (-93dB) and ideal dynamics (110dB+), plus amazing sampling rates of 384kHz.
Works with ODROID-C1 / C1+ / XU4(combination with XU4 Shifter Shield)What's better than a single LED? Lots of LEDs!
The myAHRS+ is a high performance AHRS(Attitude Heading Reference System). Its attitude output is more stable to acceleration and magnetic disturbances. Communication and configuration are enabled via UART/USB interface for user applications. I2C interface is available for embedded application like Arduino projects.
All the native GPIO pins on the XU4 operate at 1.8V. However, many devices support only 3.3V or 5V. This level shifter board contains 3 x TSX0108E bi-directional level shifter ICs. The 30-pin and 12-pin GPIO ports on the XU4 are converted to the more common 0.1inch (2.54mm) pitch 40-pin header.
Add-on sensor board for ODROID-SHOW The Weather board is an easy to use ODROID-SHOW Add-on that grants you access to UV Index, Barometric pressure, Altitude, Relative humidity, Illumination,Temperature. - Dimension is only 20 x 20 mm- Sensors : Si7020, BMP180, Si1132- Recommended working voltage : 2.7 ~ 3.6 Volt
USB to IO expansion board that provides GPIO/PWM/SPI/UART/I2C/ADC interfaces. It uses 3.3V/5V compatible PIC18F45K50-QFN USB Microcontroller. It includes 28 pin headers to make it easy to plug into a breadboard or other circuit. It has a bootloader that allows for downloading or upgrading the firmware.
for ODROID-X / X2 / U2 / U3 / XU / XU3 / W / C1 / XU4 / C1+ / C0 / C2 System console interface board for platform development and debugging. This module kit is easiest way ever to connect to your ODROID serial console port.
Xprotolab Plain Xprotolab Plain is an Oscilloscope, Logic Analyzer, Waveform & Clock generator all in one tiny, light weight and low cost package which are fully compatible with ODROID-C1/C2/XU4 Linux platforms.