PIR sensors are used to detect motion from pets/humanoids from about 20 feet away (possibly works on zombies, not guaranteed).
5 Item Items
Warning: Last items in stock!
|5||1%||Up to 0,54 €|
|20||2%||Up to 4,30 €|
|35||3%||Up to 11,29 €|
|50||4%||Up to 21,50 €|
|65||5%||Up to 34,94 €|
|80||6%||Up to 51,60 €|
|100||7%||Up to 75,25 €|
This one has an adjustable delay before firing (approx 2-4 seconds), adjustable sensitivity and we include a 1 foot (30 cm) cable with a socket so you can easily reposition the sensor or mount it using the two drills on either side
Runs on 5V-12V power (if you need to run it off of 3V you can do that by bypassing the regulator, but that means doing a bit of soldering). Digital signal output is 3.3V high/low. Sensing range is about 7 meters (120 degree cone)
For a full tutorial with wiring diagrams, CircuitPython and Arduino code examples and project ideas, PIR sensor tutorial page!
PIR sensors and the Raspberry Pi 3 sometimes don't get along - if you're having false trigger reports, make sure the PIR Sensor is far away from the Pi 3