Add an ear to your project with this well-designed electret microphone amplifier. This fully assembled and tested board comes with a 20-20KHz electret microphone soldered on. For the amplification, we use the Maxim MAX4466, an op-amp specifically designed for this delicate task!
A new collaboration between Adafruit & Micah from Scanlime, we are excited to introduce Fadecandy, a NeoPixel driver with built in dithering, that can be controlled over USB.
Specifications Antenna type: active (LNA built-in) Supported navigation satellite systems: GPS, GLONASS Dimensions: 45x35x15mm Cable length: 300mm Connector type: MCX Mounting: adhesive
Arduino Kit with microcontrollers
This new Adafruit shield makes it easy to use a 16x2 Character LCD, it lets you control a 16x2 Character LCD, up to 3 backlight pins AND 5 keypad pins using only the two I2C pins on the Arduino!
This pressure sensor from Freescale is a great low-cost sensing solution for precision measurement of barometric pressure and altitude. The MPL3115A2 has a typical 1.5 Pascal resolution, which can resolve altitude at 0.3 meters (compare to the BMP180 which can do 0.17m). It has some upsides compared to the BMP180, such as interrupt outputs for ultra-low...
SPECIFICATIONS Supports LiPo batteries up to 4SMax current sensing: 60A*Switching regulator output: 5.3V 2.25A6-pos DF13 cable for connection to Navio2 power port *power module can sense current up to 90A if different connectors are used (XT60 connectors allow for 60A max)
Reach RS cable 2m w/o 2nd connector
The best designed platform to learn robotics and programming
Le Motor Shield originel d'AdaFruit est certainement l'un des kits les plus appréciés de l'EcoSystème Arduino.
Put your project in stealth mode with these silent Soft Tactile Switch Buttons.
Slim clicky momentary switches are standard input "buttons" on electronic projects. These are half the width of classic 6mm tactile switches so they line up better on a breadboard, just plug them into every-other row.