Make your own Arduino motor party with a motor shield and a fine...
Feather is the new development board from Adafruit, and like its...
Arduino/zum compatible Open FPGA electronic board. Synthesize hardware...
Polea GT2 - 20 dientes
Polea GT2 - 16 dientes
Bloque calefactor v6 - M6
Compatible with XU / XU3 / XU4 Series4 x buttons (GPIO)1 x button (Power On)5 x LEDs (GPIO)1 x SPI Flash 2Mbit (Upto 20Mhz SPI clocking)1 x I2C Temperature/Pressure sensor BMP1801 x I2C Ambient Light sensor BH1780GLI1 x Trimpot(variable resistor) for ADC access1 x IDC cable is included.
The HiFi Shield provides both stereo RCA connectors and a 3.5mm stereo jack (all gold-plated) to connect to external amplifiers and other audio equipment. Via TI's high-end PCM5102 DAC chip, it supports 16, 24, 32 bit audio formats with minimal distortion (-93dB) and ideal dynamics (110dB+), plus amazing sampling rates of 384kHz.
Works with ODROID-C1 / C1+ / XU4(combination with XU4 Shifter Shield)What's better than a single LED? Lots of LEDs!
The myAHRS+ is a high performance AHRS(Attitude Heading Reference System). Its attitude output is more stable to acceleration and magnetic disturbances. Communication and configuration are enabled via UART/USB interface for user applications. I2C interface is available for embedded application like Arduino projects.
Add-on sensor board for ODROID-SHOW The Weather board is an easy to use ODROID-SHOW Add-on that grants you access to UV Index, Barometric pressure, Altitude, Relative humidity, Illumination,Temperature. - Dimension is only 20 x 20 mm- Sensors : Si7020, BMP180, Si1132- Recommended working voltage : 2.7 ~ 3.6 Volt
USB to IO expansion board that provides GPIO/PWM/SPI/UART/I2C/ADC interfaces. It uses 3.3V/5V compatible PIC18F45K50-QFN USB Microcontroller. It includes 28 pin headers to make it easy to plug into a breadboard or other circuit. It has a bootloader that allows for downloading or upgrading the firmware.
Xprotolab Plain Xprotolab Plain is an Oscilloscope, Logic Analyzer, Waveform & Clock generator all in one tiny, light weight and low cost package which are fully compatible with ODROID-C1/C2/XU4 Linux platforms.